What's New in MatrixPro Remote Control Panel Software Version 1.03
          Copyright (c) 2005 by Barco Folsom LLC.,
                      All Rights Reserved.              


Thank you for using the MatrixPro product. This What's
New file contains important information regarding this
release. Barco Folsom strongly recommends that you
read the entire document.

Barco Folsom welcomes your comments and suggestions.
Please use the information provided in this file to contact
Customer Service or Technical Support.

Note: When printing this document, choose Landscape for 
      page orientation.

___________________
WHAT'S IN THIS FILE

- New Features
- Improved Functionality
- Installation
- Contacting Barco Folsom LLC.


************************ Version 1.03 *********************************
- Initial release

- The Matrix Pro Remote Controller (MPRC) comes with a PC application 
  to configure the IP address of the MPRC and the target (router).
  Without this utility, users can still configure the IP address using
  the MPRC front panel, however the range of avaliable IP address will
  be limited to 192.168.0.201 to 192.168.0.216 for the MPRC and
  192.168.0.241 to 192.168.0.243 for the routers.

- To Change IP address using the front panel.
  Press and hold the Network Address Button. (using a pen or a pin)  The
  LED on the output button bus will be turned off, and an LED on the 
  input button bus will be lit to indicate the IP address for the MPRC.
  button 1 to 16 correspond to IP address 192.168.0.201 to 192.168.0.216.
  (If there is no LED that is lit, the MPRC is using a custom IP address
  out of this range)  To change it, simply press one of the buttons.
  Press and hold the Network Address Button a second time, the
  LED on the output button bus will be turned off, and an LED on the 
  input button bus will blink to indicate the IP address for the router.
  button 1 to 3 correspond to IP address 192.168.0.241 to 192.168.0.243.
  button 16 is a custom IP address for the router.  The other are invalid.
 
- To change IP address using the MPRC Ethernet Configuration utility.
  Connect a serial cable from the PC to the MPRC being configured.
  Run the MPRC Ethernet Configuration utility from the folder that the 
  MPRC is installed.  Choose the com port that the MPRC is connected to.
  The program will show the unit and target IP address for the connected
  unit.  To change the IP address, simply type the IP address on the 
  text box for the unit or target IP address, and click the corresponding
  button.  (Remember to also set the ip address on the router if necessary,
  as the program only affect MPRC's settings.)
  Alternatively, Defaults IP addresses can be used by clicking the "Defaults"
  Menu and choosing the appropiate default. Below is a list of Defaults values:

	Router 		MPRC IP address		Router IP address
	Analog		192.168.0.201		192.168.0.241
	SDI		192.168.0.202		192.168.0.242
	DVI		192.168.0.203		192.168.0.243

  Note:  The MatrixPro routers and the MPRC assumes that the network 
	subnet mask to be 255.255.255.0.  The system might not work on 
	different kind of subnet. 


____________
INSTALLATION

Refer to the upgrade_instructions.txt file contained in the 
MatrixPro_Remote_Control_Rev###.exe file for instructions on upgrading your
Matrix Pro Remote Panels to this release of software.


____________________________
CONTACTING BARCO FOLSOM LLC.

Should you have any comments or questions about this release or any
other product, please point your web browser to www.folsom.com for 
current contact information.